Why whole house inspection must include Anti–scald valves inspection? Warm and hot showers in winters are unarguably the best feeling, but all the while that we seem to enjoy this hot water, it might lead to bacterial growth and can scald badly. This can be very dangerous, especially for the children because of their soft skin. Now this just stings a bit. Don’t it? But, we have an all-rounder for this problem known as anti-scald valve. This thermal mixing valve is the most straightforward and relatively inexpensive way to protect yourself and your family against burn injuries. They are almost present everywhere all home inspection services must inspect them during whole house inspection .
How a whole house inspection affects your safety?
The most fundamental purpose of an anti-scald valve is to alleviate the intensity of hot water by automatically combining cold water even if the water fluctuations take place within the pipelines.
Talking about whole house inspection, buying a house or even a small apartment without it will certainly be a brainless decision without any exaggeration and may cost you a handsome amount of money on repairs in the future. Out of all the other manifold ways contributing to the Toronto house inspection process such as inspecting the water and septic system, roof and floor structure, wires, porches and so on, anti-scald valve inspection plays a major role. This article is meant to give you a good idea of what to do during a home inspection or what does a home inspector look for in different types of home inspections with reference to anti-scald valves.
Useful tips for anti-scald inspection during a whole house inspection :
- The inspector or the householder should make sure that the boilers high temperature does not exceed the maximum rating and there should be check-valves already installed. If not, the buyer should be informed since check valves make sure that the water is consistent in flowing in one direction and they also prevent siphoning of hot and cold water.
- All mixing valves should be inspected during a whole house inspection for its service and repair.
- All the valves initially installed just by the source should be trapped. This will help reduce mineral deposits and premature component wear.
- Heat traps help reduce convection loss (also known as thermo-siphoning) which will lead to an ultimate increase in efficiency.
- However, this nearly impeccable device does uphold some cons as well (though just petty). The installation, if not done meticulously, can cause irregularities in the water temperature and alter the consistency. Users will then have to alter the temperature according to their requirement. What does a home inspector look for in such installations is basically the correctness.
Conclusively, anti-scald valves are considered to be most convenient when it comes to providing the suitable water temperatures for bathing, washing etc. They not only protect people from burn injuries, but also save up money that may later be medical expenses for burn injuries.
Therefore, as part of making a wise decision before buying a house this factor should not, at any cost, be neglected always make sure that a whole house inspection includes anti-scald valve inspection.
[wpseo_address show_state=”1″ show_country=”1″ show_phone=”1″ show_phone_2=”0″ show_fax=”1″ show_email=”1″ show_opening_hours=”1″]
[wpseo_map width=”400″ height=”300″ zoom=”-1″ map_style=”roadmap” scrollable=”1″ show_route=”0″ show_state=”0″]